CHECK FOR DAMAGED OR WORN PARTS
Contact Sears Service Center for re- placement of damaged or worn parts.
•ON/STOP Switch - Ensure ON/STOP switch functions properly by pushing and releasing the switch. Make sure engine stops. Wait 5 seconds before attempting to restart unit to allow
switch to reset. Restart engine and continue.
•Fuel Tank - Discontinue use of unit
if fuel tank shows signs of damage or leaks.
•Debris Shield - Discontinue use of
unit if debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
•After each use, inspect complete unit for loose or damaged parts. Clean the unit and labels using a damp cloth with a mild detergent.
•Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine per- formance and increases fuel con-
sumption and harmful emissions. Al- ways clean after every 5 hours of operation.
1.Clean the cover and the area
around it to keep dirt from falling into the carburetor chamber when the cover is removed.
2.Remove parts by pressing latch to release air filter cover.
NOTE: To avoid creating a fire hazard or producing harmful evaporative
emissions, do not clean filter in gaso- line or other flammable solvent.
3.Wash the filter in soap and water.
4.Allow filter to dry.
5.Add a few drops of oil to the filter; squeeze the filter to distribute oil.
6.Replace parts.
LINE REPLACEMENT
1.Press the tabs on the side of the trimmer head and remove cover
and spool.
Cover
Tap Button
Button
Air Filter
Air Filter Cover
INSPECT MUFFLER AND SPARK ARRESTING SCREEN
'_WARNING: | The muffler on this |
product contains chemicals known to the State of California to cause cancer.
_,WARNING: | Muffler is very hot |
during and after use. Do not touch the muffler or allow combustible material
such as dry grass or fuel to do so. As your unit is used, carbon deposits build up on the muffler and spark ar- resting screen. For normal homeown- er use, however, the muffler and spark arresting screen will not require any service. After 50 hours of use, we rec- ommend that your muffler be serviced or replaced by your Sears Service Cen- ter.
REPLACE SPARK PLUG
Replace the spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at
0.025 inch (0.6 ram). Ignition timing is fixed and
nonadjustable.
1.Twist, then pull off spark plug boot.
2.Remove spark plug from cylinder and discard.
3.Replace with Champion
with a 3/4 inch (19 mm) socket wrench.
4.Reinstall the spark plug boot.
2.Remove any remaining line.
3.Clean dirt and debris from all
parts. Replace spool if it is worn or damaged.
4.Replace with a
inch (2.4 mm) diameter Craftsman brand line.
5.When installing new line on an ex-
isting spool, hold the spool as shown in the illustration below.
16
