Craftsman 358.791051 manual Trimmer Line Advance, Cutting Methods, RightWrong

4_WARNING: Always wear eye

protection. Always use hearing protec- tion. Never lean over the trimmer head.

Rocks or debris can ricochet or be

thrown into eyes and face and cause blindness or other serious injury. When operating unit, stand as shown and check for the following:

•Wear eye protection and heavy clothing.

•Hold trigger handle with right hand and assist handle with left hand.

•Hold unit so that engine is below waist level.

•Out only from your left to your right to ensure debris is thrown away from you. Without bending over, keep line

near and parallel to the ground and not crowded into material being cut.

Do not run the engine at a higher speed than necessary. The cutting line will cut efficiently when the engine is run at less than full throttle. At lower speeds, there is less engine noise and vibration.

The cutting line will last longer and will be less likely to "weld" onto the spool. Always release the throttle trigger and allow the engine to return to idle speed when not cutting.

HOW TO STOP YOUR UNIT

•Release the throttle trigger.

•Push and release the engine ON/ STOP switch.

TRIMMER LINE ADVANCE

The trimmer line will advance approxi- mately 2 inches (5 cm) each time the bottom of the trimmer head is tapped

on the ground with the engine running at full throttle.

The most efficient line length is the maximum length allowed by the line limiter. Always keep the shield in place

when the tool is being operated. To advance line:

•Operate the engine at full throttle.

•Hold the trimmer head parallel to and above the grassy area.

•Tap the bottom of the trimmer head

lightly on the ground one time. Ap- proximately 2 inches (5 cm) of line will be advanced with each tap.

Always tap the trimmer head on a grassy area. Tapping on surfaces such

as concrete or asphalt can cause ex- cessive wear to the trimmer head.

If the line is worn down to 2 inches (5 cm) or less, more than one tap will be required to obtain the most efficient line length.

_I=WARNING: Use only 0.095 inch (2.4 ram) diameter line. Other sizes of line will not advance properly and will result in improper cutting head func- tion or can cause serious injury. Do not use other materials such as wire, string, rope, etc. Wire can break off

during cutting and become a danger- ous missile that can cause serious in-

jury.

CUTTING METHODS

A_,WARNING: Use minimum

speed and do not crowd the line when cutting around hard objects (rock, gravel, fence posts, etc.), which can damage the trimmer head, become entangled in the line, or be thrown causing a serious hazard.

•The tip of the line does the cutting. You will achieve the best perform- ance and minimum line wear by not crowding the line into the cutting

area. The right and wrong ways are shown below=

Tip of the line	Line crowded into
does the cutting,	work area,

RightWrong

•The line will easily remove grass and weeds from around walls, fences, trees and flower beds, but it also can cut the tender bark of trees or shrubs and scar fences.

•For trimming or scalping, use less than full throttle to increase line life

and decrease head wear, especially:

•During light duty cutting.

•Near objects around which the line

can wrap such as small posts, trees or fence wire.

•For mowing or sweeping, use full throttle for a good clean job.

TRIMMING - Hold the bottom of the

trimmer head about 3 inches (8 cm) above the ground and at an angle. Al- low only the tip of the line to make

contact with vegetation. Do not force trimmer line into work area.

14