Craftsman 358.79476 Blower USE I Vacuum USE, Know Your Blower, Throttle Trigger, Primer Bulb

SHOULDER STRAP ATTACHMENT (optional accessory #71-85783)

1.Pass the shoulder strap over your head and onto your left shoulder.

2.Snap the hook onto the retainer (see following illustration).

BLOWER USE I VACUUM USE

Retainer __ II J_S_: ._,'_

KNOW YOUR BLOWER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR

UNIT.	Compare	the illustrations with your unit to familiarize			yourself	with the location
of the	various	controls	and adjustments.	Save this manual	for future	reference.
Throttle Position Lever				Elbow Tube
			Upper Vacuum	Tube

STOP Switch

	Throttle Trigger	Lower Vacuum Tube
	Spark Plug
Starter	Upper Blower Tube
		Lower Blower Tube	High-
			Speed

R°P X	Nozzle
Fuel Mix
Fill Cap

Primer
Bulb	Vacuum Handle
STOP SWITCH

The STOP switch is used to stop the engine. To stop the engine, push and hold the STOP switch in the STOP posi- tion until the engine stops.

THROTTLE TRIGGER

The THROq-i-LE TRIGGER is used to se-

lect the desired engine speed.

THROTTLE POSITION LEVER

The THRO]q-LE POSITION LEVER is de-

signed to allow setting engine speed during blower use only. To avoid caus- ing damage to the unit, DO NOT at- tempt to use the throttle position lever during vacuum use.

PRIMER BULB

The PRIMER BULB removes air from the carburetor and fuel lines and fills them

with fuel. This allows you to start the en- gine with fewer pulls on the starter rope. Activate primer bulb by pressing it and

allowing it to return to its original posi- tion.

START LEVER

The START LEVER helps to supply fuel to the engine to aid in starting. Activate the starting system by moving the start lever to the START position. DO NOT squeeze the throttle trigger until the engine has started and runs. After the engine starts, allow the engine to warm- up 10-15 seconds, then fully squeeze the throttle trigger to deactivate the starting system (start lever returns to RUN position).

-8-