h.Pull on the nylon line to change the spool from the lockedposition to the operating position. Figure 24.
Obtain correct line length by pressing tap button and pulling on nylon line again.
NOTE: Approximately 2 inches of line can be advanced each time the tap button is pressed.
Figure 24.
USE ONLY SEARS/CRAFTSMAN ®
REPLACEMENT PARTS
2.CUTTING LINE REPAIR
•If the cutting line breaks off or backs up in the cutting head, follow "Cutting Line Replacement", omittingstep "e".
3.SPOOL REPLACEMENT
a Replace the spool when: The square corners of the drive lugs are rounded off, reduced in size, or broken off. Figure 25.
b. To replace the spool, follow "Cutting Line Replacement" (page 12).
4.LINE LIMITER MAINTENANCE
• The line limiter is the metal blade found on the splash deflector.
--allow fast, easy
avoid excessive wear to the cutting head.
•• To sharpen:
Use a fiat file and file from the outside toward the inside of the line limiter,Figure 26.
in
Approximately2 inches of line canbe advanced
eachtime the Tap Button
is pressed.
TAP BUTTON
Figure 24
NORMAL SPOOL | WORN SPOOL |
iii
Figure 25
Figure 26
NOTES
13
