Craftsman 486.242211 STEP 13: (FIGURE 17), STEP 14: (FIGURE 18), STEP 15: (SEE FIGURE 19 AND 20), lower, FIGURE, FIGURE, FIGURE, FIGURE, IMPORTANT: Do not

STEP 13: (FIGURE 17) STEP 15: (SEE FIGURE 19 AND 20)

IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the steel rods to loose supporting tension.

•Tip the hopper onto it's back to assemble the two hopper support rods. Place the ends of each rod into the upper and lower rear hopper tubes, bending the rod just enough to fit into the holes in the tubes.

•Secure the rope to the top center of the hopper bag frame.

FLAP

SNAP

FIGURE 17

STEP 14: (FIGURE 18)

•Insert a 3/8" x 3" clevis pin (R) through the lower hole in each upper hopper side tube. Next assemble a bag arm tube onto each clevis pin and secure it with a 3/32" hair cotter pin (N).

•Assemble a vinyl cap (V) onto the end of each bag arm tube.

LOWER HOLE	3/32" HAIR
	COTTER PIN (N)
	3/8" x 3"
VINYL CAP (V)	CLEVIS PIN (R)
	BAG ARM TUBE

FIGURE 18

FIGURE 19

•To assemble the hopper bag to the sweeper, slide the ends of the bag arm tubes into the ends of the sweeper's hitch tubes and secure with two 1/4" x

1-3/4" clevis pins (Q) and 3/32" hair cotter pins (N).

BAG ARM TUBE
3/32" HAIR	1/4" x 1-3/4"
COTTER PIN (N)	CLEVIS PIN (Q)

FIGURE 20

10