STEP 3: (SEE FIGURE 3)
•Attach the brush assembly with the black brush retainer to the left end of the brush shaft using two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The brush retainer marked with black ink must be placed to the middle of the sweeper.
•Turn a wheel to rotate the brushes. (The wheels drive the brushes in one direction only.) The overlap bristles should be on the back side of the brush as it rotates.
1/4" x 1"
HEX BOLT (G)
BRUSH RETAINER
MARKED BLACK
1/4" NYLOCK NUT (I)
FIGURE 3
STEP 4: (SEE FIGURE 4)
•Cut off the plastic tie that holds the height adjustment tube in place.
•Assemble the R.H. hitch tube to the sweeper housing using two 5/16" x
5/16" NYLOCK NUT (J)
5/16" x
CARRIAGE BOLT (C)
FIGURE 4
STEP 5: (SEE FIGURE 5)
•Fasten the hitch tubes together using two 5/16" x
5/16"
NYLOCK NUT (J)
5/16" x
FIGURE 5
6