STEP 19: (SEE FIGURE 17)
•Slide the end of the pivot rod through the upper hopper tube. Place a bag arm tube onto the rod. Slide the rod through the stitched sleeve at the front edge of the wind screen, and then place another bag arm tube onto the rod. Slide the rod through the other upper hopper tube.
WIND SCREEN
HOPPER BAG
PIVOT ROD
BAG ARM TUBE
FIGURE 17
STEP 20: (SEE FIGURE 18)
•Assemble a vinyl cap (O) onto each bag arm tube.
•Assemble two palnuts (H) onto the ends of the pivot rod using a hammer.
HINT: To ease assembly of the palnuts, place the bag on its side on a solid surface. With the bottom end of the pivot rod against the surface, tap a palnut onto the top end of the rod. Repeat for other end of rod.
CAP (O)
PALNUT (H)
FIGURE 18
STEP 21: (SEE FIGURE 19)
•Secure the rope to the center of the upper rear hopper tube.
FIGURE 19
STEP 22: (SEE FIGURE 20)
•To attach the hopper bag to the sweeper, slide the ends of the bag arm tubes into the ends of the hitch tubes and secure with two clevis pins (J) and hairpin cotters (M).
BAG ARM TUBE
CLEVIS PIN (J)
HAIRPIN
COTTER (M)
FIGURE 20
10