ASSEMBLY OF HOPPER BAG
STEP 12: (SEE FIGURE 10)
•Fit the ends of the two upper hopper tubes into the ends of a rear hopper tube. Align the holes in the ends of the tubes and secure them in place using two curved head bolts (E) and nylock nuts (F).
•Fit the ends of the two lower hopper tubes into the ends of a rear hopper tube. Align the holes in the ends of the tubes and secure them in place using two curved head bolts (E) and nylock nuts (F).
NOTE: Either side of the rear hopper tube can face up.
REAR
HOPPER
TUBE
| CURVED HEAD | |
| BOLT (E) | |
NYLOCK | UPPER | |
NUT (F) | ||
HOPPER | ||
| ||
| TUBE |
NYLOCK
REARNUT (F)
HOPPER
TUBE
CURVED HEAD 
BOLT (E)
LOWER 
HOPPER TUBE
FIGURE 10
STEP 13: (SEE FIGURE 11)
•Unfold the hopper bag, reverse the fold of the mesh wind screen and then lay the bag out flat with the wind screen on top.
•Insert the ends of the assembled upper hopper tubes down through the stitched sleeves in the sides of the hopper bag and then slide the tubes back underneath the wind screen.
STITCHED SLEEVE
UPPER
HOPPER
TUBE
HOPPER
BAG
BOTTOM
FIGURE 11
STEP 14: (SEE FIGURE 12)
•Place the assembled lower hopper tubes into the bottom of the hopper bag and then slide the tubes to the back of the bag.
•Attach the ends of the lower hopper tubes to the inside of the upper hopper tubes using two clevis pins (L) inserted from the inside, and two hair cotter pins (M).
UPPER HOPPER
TUBE
HAIR COTTER
PIN (M)
LOWER HOPPER TUBE
CLEVIS PIN (L)
HOPPER BAG
BOTTOM
FIGURE 12
8