Craftsman 486.242223 TOOLS REQUIRED FOR ASSEMBLY, STEP 1 - REMOVE PARTS FROM CARTON, STEP 3: (SEE FIGURE 2), STEP 2: (SEE FIGURE 1), STEP 4: (SEE FIGURE 3)

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(1)Hammer

(2)7/16" Wrenches

(2)1/2" Wrenches

STEP 1 - REMOVE PARTS FROM CARTON

•To protect painted parts, lay them on cardboard or a mat.

•Remove the sweeper housing, the loose parts and the hardware package from the carton. Lay out the parts and hardware as shown on pages 3 and 4.

•Place the sheet of cardboard from inside the carton onto your work surface to prevent scratching the sweeper.

STEP 3: (SEE FIGURE 2)

•Tip the sweeper forward to access the brush shaft.

STEP 2: (SEE FIGURE 1)

•Each brush assembly has one brush retainer marked with either red or black ink. Lay out the brush assemblies as shown so that the brush retainers marked with ink are in the middle with the black one on your right and the red one on your left.

BRUSH RETAINER

MARKED BLACK

BRUSH RETAINER

MARKED RED

OVERLAP BRISTLES

FIGURE 1

FIGURE 2

STEP 4: (SEE FIGURE 3)

IMPORTANT: Be sure the overlap bristles face out when a brush is rotated to the bottom position.

•Attach the brush assembly with the black brush retainer to the right end of the brush shaft using two hex bolts (D) and nylock nuts (F). The brush retainer marked with black ink must be placed to the middle of the sweeper.

NYLOCK NUT (F)

WELDED BRACE

HEX BOLT (D)

BRUSH

RETAINER

MARKED

BLACK

OVERLAP

BRISTLES

FIGURE 3

5