STEP 15: (SEE FIGURE 13)
•Insert the bag frame strap into the stitched sleeve at the front edge of the bag bottom.
BAG FRAME STRAPSTITCHEDSLEEVEFIGURE 13
STEP 17: (SEE FIGURE 15)
•Fold the bag flaps around the lower hopper tubes and attach to the bag bottom using the snaps.
SNAP FLAPFIGURE 15
STEP 16: (SEE FIGURE 14)
•Assemble the bag frame strap to the holes in the lower hopper tubes using two clevis pins (K) and hair cotter pins (M).
BAG FRAME STRAP
HAIR COTTER PIN (M)CLEVIS PIN (K)FIGURE 14
STEP 18: (FIGURE 16)
IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the steel rods to loose supporting tension.
•Tip the hopper onto it's back to assemble the two hopper support rods. Place the ends of each rod into the upper and lower rear hopper tubes, bending the rod just enough to fit into the holes in the tubes.
SUPPORT
RODS
FIGURE 16
9