Craftsman 486.242223 STEP 5: (SEE FIGURE 4), STEP 7: (SEE FIGURE 6), STEP 6: (SEE FIGURES 5 AND 6), STEP 8: (SEE FIGURE 7), away, middle, FIGURE, toward, FIGURE, FIGURE, FIGURE

STEP 5: (SEE FIGURE 4)

•Attach the brush assembly with the red brush retainer to the left end of the brush shaft using two hex bolts

(D) and nylock nuts (F). The brush retainer marked with red ink must be placed to the middle of the sweeper.

•Turn a wheel to rotate the brushes. (The wheels drive the brushes in one direction only.) The overlap bristles should be on the back side of the brush as it rotates.

HEX BOLT (D)

BRUSH RETAINER

MARKED RED

NYLOCK NUT (F)

FIGURE 4

STEP 7: (SEE FIGURE 6)

•Hold the right hitch tube against the right side of the sweeper so that the "76R" on the tube faces toward the sweeper. Attach the hitch tube using two hex bolts

HEX BOLT (C)

NYLOCK NUT (G)

HOUSING MARKED “R”

TUBE

MARKED

“76R”

HITCH TUBE (R.H.)

FIGURE 6

STEP 6: (SEE FIGURES 5 AND 6)

•The hitch tubes are stamped with a "77L" for the left tube and a "76R" for the right tube. The sweeper housing is marked with an "L" on the left with side and an "R" on the right side.

•Hold the left hitch tube against the left side of the sweeper so that the "77L" on the tube faces away from the sweeper. Attach the hitch tube using two hex bolts (C) and nylock nuts (G). Do not tighten yet.