THIS SECTION IS FOR TRACTORS WITH AN
ELECTRIC ATTACHMENT CLUTCH
STEP 14: (SEE FIGURE 14)
•Turn the clutch idler assembly upside down.
•Hook the spring onto the end of the bolt that extends through the nut on the bottom of the upper idler arm. Install a 3/8" hex lock nut onto the bolt, leaving enough space for the spring to pivot.
SPRING
3/8" HEX F'
STEP 18: (SEE FIGURE 16)
Attach each rear pulley frame bracket to the inside of the clutch/idler assembly using two 5/16" x 3/4" hex bolts, 5/16" washers and 5/16" nylock nuts.
Attach each front pulley frame bracket to the inside of the clutch/idler assembly using two 5/16" x 1" hex bolts, four 5/16" washers and two 5/16" nylock nuts.
5116" x 1" HEX BOLT
LOCK NUT
ATTACH
SPRING
HERE
FIGURE 14
©
(2) 5116" WASHERS
| / |
| 5116" |
5116" x 314" | NYLOCK NUT |
| |
HEX BOLT | "_ |
5/16" WASHER | / |
5/16" NYLOCK | NUT |
FIGURE 16
STEP15: (SEE FIGURE 15)
Insert tensioning chains through the holes shown and attach to the springs on the upper and lower idler arms. Install a 3/32" hairpin cotter in the chain attached to the upper idler arm, placing it in the fifth link from the spring.
TENSIONING CHAIN (upper idler arm)
3132" HAIRPIN
//COTTER IN 5th LINK
TENSIONING CHAIN (lower idler arm)
FIGURE 15
SELECTTHE CORRECT DRIVE BELT
(Electric clutch tractors with a single front deck
suspension bracket)
STEP 17: (SEETABLE 1)
Three different length drive belts are included with your snow thrower. Select one of the two belts listed below that is correct for your tractor. The part number is printed on the outside of the belt.
•Set aside the belts that are not for your tractor, to avoid accidentally using them.
55" BELT (PART #46989)
TRACTOR TYPE | DECK SIZE | CLUTCH TYPE |
(LT) Lawn Tractor | 38", 42" | Electric |
56" | BELT (PART #48138) | |
TRACTOR TYPE | DECK SIZE | CLUTCH TYPE |
(LT) Lawn Tractor | 48" | Electric |
(GT) Garden Tractor | 48", 54" | Electric |
TABLE 1 |
|
|
12
