LOCATE TRACTOR'S MODEL LABEL
Look under your tractor seat to locate the model number label shown below. This manual if for tractors with model numbers that start with 917 as shown below.
917 MODEL TRACTORS
CRRFTXllIRH+
CONFORMS TO ANSi B71,1=2003 SAFETY STANDARDS
III1 1111111 IIIIIIIl lllllllllll
SERIAL 000000A000000
FOR PARTS AND SERVICE CAll
SEARS, ROEBUCK AND CO, Iloffman Estates, I[ 60179
193653 j
IMPORTANT: If your model number starts with 247, use the owner's manual and the parts that are contained in the other parts bag.
TOOLS REQUIRED FOR ASSEMBLY
(2)7/16" Wrenches
(2)1/2" Wrenches
(2)9/16" Wrenches
(2)3/4" Wrenches
(1)Screw Driver
(1)Knife
ADDITIONAL ITEMS REQUIRED
General Purpose Grease
REMOVAL OF PARTS FROM CARTON
Remove all loose parts, parts bags and hardware bags from the carton. Lay out and identify parts and hardware using the illustrations on pages 4, 5 and 6. The parts bag labeled for 247 model tractors will not be needed.
IMPORTANT: Not all items supplied in the hardware bag will be needed for your particular tractor. Unneeded items may be discarded after you have completed assembly and checked operation of unit. DO NOT DISCARD the two spare shear bolts and 5/16" nylock nuts. Refer to the Service and Adjustments section on page 28.
CAUTION: Before starting to assemble the snow thrower, remove the spark plug wire(s), set the parking brake and remove the key from the tractor ignition.
TRACTOR PREPARATION
Before performing these instructions, refer to the Service and Adjustments section of your tractor owner's manual for specific safety instructions.
•Allow engine, muffler and exhaust deflector to cool before beginning.
•Remove any front or rear attachment which is mounted to your tractor.
•Remove the mower deck. Refer to your tractor owner's manual for removal instructions. Mark all loose parts and save for reassembly.
•Remove the tractor hood. Refer to your tractor owner's manual for removal instructions.
IMPORTANT: Right hand (R.H.) and left hand (L.H.) side of the tractor are determined from the operators position while seated on the tractor.