ELECTRICATTACHMENTCLUTCHES
STEP41: (SEEFIGURE41)
•Turntheclutchidlerassemblyupsidedown.
Hookthespring(ontotheendoftheboltthatextends throughthenutonthebottomoftheupperidler arm.Installa3/8"hexlocknutontothebolt,leaving enoughspaceforthespringto pivot.
SPRING
3/8" HEX F'
STEP 43: (SEE FIGURE 43)
Attach the two rear pulley frame brackets to the inside of the clutch/idler assembly using two 5/16" x 1" hex
bolts, eight 5/16" washers and two 5/16" nylock nuts for each bracket.
Attach the two front pulley frame brackets to the inside of the clutch/idler assembly using two 5/16" x 3/4" hex
bolts, 5/16" washers and 5/16" nylock nuts for each bracket.
5116" x 3/4" HEX BOLT
LOCK NUT
ATTACH
SPRING
HERE
©
5116"
WASHER
/
FIGURE 41 | BOTTO M Vl EW |
STEP 42: (SEE FIGURE 42)
Insert tensioning chains through the holes shown and attach to the springs on the upper and lower idler arms. Attach a 3/32" hairpin cotter to the chain attached to the upper idler arm, placing it in the fifth link from the spring.
TENSIONING CHAIN (upper idler arm)
3/32" HAIRPIN
111 COTTER IN
5th LINK
TENSIONING CHAIN (lower idler arm)
FIGURE 42
5116" x 1"
HEX BOLT
(4)5116" WASHERS /
/
5116" NYLOCK NUT
FIGURE 43
STEP 44: (SEE TABLE 2)
Three different length drive belts are included with your snow thrower. Select one of the two belts listed below that is correct for your tractor. The part number is printed on the outside of the belt.
Set aside the belts that are not for your tractor, to avoid accidentally using them.
55" BELT (PART #46989)
TRACTOR TYPE DECK SiZE CLUTCH TYPE
(LT) Lawn Tractor | 38", 42", 46" | Electric |
56" BELT (PART #48138)
TRACTOR TYPE DECK SiZE CLUTCH TYPE
(LT) Lawn Tractor | 48" | Electric |
TABLE 2
20
