Quadra-Fire DV-40 manual Thermostat Installation, Remote Control, Blower Power Cord

THERMOSTAT INSTALLATION

If desired, a thermostat may be installed to regulate the Quadra-Fire DV-40 Step. It is important to use a thermostat designed for millivolt operation. Do not connect this stove to a thermostat serving any other appliance. Bedroom installation in Canada requires this stove to be hooked to a thermostat.

OPTIONAL THERMOSTATS

Manual Thermostat

Part #812-2880

Anticipator Setting 1.2

Programable Thermostat

Part #811-0520

RECOMMENDED MAXIMUM LEAD

LENGTH (TWO WIRE) WHEN USING

WALL THERMOSTAT/SWITCH

Wire Size	Maximum Length
16 gauge	65 feet
18 gauge	40 feet
20 gauge	25 feet
22 gauge	18 feet

Thermostat

Connection

Connect the thermostat wires to the outside terminals labled “TH” and “THTP” located on the valve. Turn off the manual switch, located on the control panel.

REMOTE CONTROL

A remote control or a wall switch may be wired to the thermostat terminals. Contact your Quadra-Fire dealer or service person for details (see page 45 for part number).

BLOWER POWER CORD

The blower cord is located at the rear of the stove, and needs to be routed to a three-prong outlet with correct polarity. Be sure that the stove is electrically grounded in accordance with local codes, with a current version of CSA C22.2 No. 3 M1988 (in Canada), or in the absence of local codes, with the National Electric Code ANSI/NFPA 70-1987.

WARNING

Do not cut the grounding terminal off under any circumstances.

Do not route the power cord under the body of the stove due to high temperatures.

Page 9