VENTING INSTRUCTIONS
PLEASE NOTE: In order to comply with applicable codes and product warranties, only Simpson Dura- Vent venting components may be used. DO NOT USE
The
IMPORTANT
Read all these instructions carefully before starting the installation. Failure to follow instructions may create a fire or other safety hazard, and will void the warranty. Be sure to follow these installation instructions for venting and clearance to combustible requirements, which may vary from one installation to another.
Do not extend the venting system in excess of the distance prescribed in these manufacturer’s installation instructions.
INSTALLATION PRECAUTIONS
The
Any vertical termination greater than 10’ (ten feet) needs a restrictor strap placed in the top of the 4” (four inch) exhaust outlet of the appliance. Any horizontal termination with greater than 10’ (ten feet) of vertical rise requires this same restrictor strap. (See Pg. 45, Restrictor strap part
WARNING: Always maintain the required clearances (air space) to nearby combustibles to avoid creating a fire hazard. Do not fill air space with insulation. Minimum clearance between vent pipes and combustible surfaces is 1” (25mm), except where stated otherwise. Be sure to check the vent termination clearance requirements from decks, windows, soffits, gas regulators, air supply inlets and public walkways, as specified in these installation instructions and local building codes. (Refer to page 18 for horizontal installation instructions.)
The gas stove and vent system must be vented directly to the outside of the building, and never be attached to a chimney serving a separate solid fuel or
SAFETY PRECAUTIONS FOR THE INSTALLER
Wear gloves and safety glasses for protection when installing this stove. Exercise extreme electrical caution when using ladders or on rooftops. Be aware of electrical wiring locations in walls and ceilings.
Page 16