STEP45: (SEEFIGURE44)
*Turnthedutch/idlerassemblyrightsideup.
*Slightly loosen the hex bolt next to the flat idler pulley.
Install the drive belt down between timehex bolt and the flat idler pulley with the fiat side of the belt against the pulley. Retighten the hex bolt.
*Loop the belt around the large
BEX BOLTS | PLATIDLER |
| PULLEY |
\
\
\
STEP 47: (SEE FIGURE 46)
Assemble the drive belt onto the engine pulley and then onto the large pulley on top of the dutch/idler assembly. The belt must be placed to the inside of the idler pulley and the keeper bolt located beside the large pulley
•Place tension on the belt by pulling the left side tensioning chain out as far as the 3/32" hairpin cotter
(LL)will allow Secure the chain in this position by inserting a 1/8" hairpin cotter (KK) through the chain
IMPORTANT: Do Not assemble the "V" belt around the
outside of the engine pulley keeper or the keepe_ bolt.
CLUTCH/IDLER ASSEMBLY
Left Side
of Tractor
FIGURE 44
Did you choose the correct drive belt for your tractor? Using the wrong length belt may cause premature bearing or belt failure.
PULLEY
IDLER
1/8" HAIRPIN COTTER (KK)
/
STEP 46: (SEE FIGURE 45)
Attach the clutchddler assembly to the tractor frame as follows. Hook the assembly's notched arms onto the two shoulder bolts you assembled to the inside of the tractor frame. Lift the front of the assembly and attach it to the RH and L.H hanger brackets using two pivot lock pins (MM) and 1/8" hairpin cotters (KK)
1/8" HAIRPIN COTTER (KK)
" | PIVOT LOCK PIN (MM) |
" _ KEEPER
ii BOLT
FIGURE 46VIEWED FROM UNDERNEATH
FIGURE 45 | RIGHT SIDE VIEW |
20
