COLDSTART(Seefigureonthispage)

Electric Starter

Be sure the auger ddve lever is in the

 

disengaged (Released) position,

Move the throttle control to '_ (Fast)

 

position.

Remove the keys from the plastic bag.

 

Insert one key into the ignition slot. Be

 

sure it snaps into place. DO NOT TURN

 

KEY. Keep the second key in a safe

 

place.

Rotate the choke control to H

 

choke ON position.

• Connect the power cord to the switch box

 

on the engine.

Primer

Button

Ignition

Key

Control

Starter Handle

Plug the other end of the power cord into

a three-hole, grounded 120 volt A.C,

receptacle.

Push the pnmer button while covering the

vent hole as follows: (remove finger from

primer button between primes).

Do not prime if temperature is above

50°F.

Two times if temperature is 50°F to 15°F.

Four times if temperature is below 15°F.

Push down on the starter button until the

engine starts. Do not crank for more than 10 seconds at a time. This electric starter

is thermally protected. If overheated it will stop automatically and can be restarted

only when it has cooled to a safe temperature (a wait of about 5 to 10 minutes is required).

When the engine starts, release the starter button and move choke lever to

"1/2 choke" position. When engine runs smoothly, move choke lever to "No

Choke" Position.

Disconnect the power cord from the receptacle first and from the switch box on engine.

NOTE: Allow the engine to warm up for several minutes before blowing snow in temperatures below 0°F.

Run the engine at full throttle _ (Fast) when throwing snow.

Z_, CAUTION: Gasoline is flammable and caution must be used when handling or stor- ing it.

Do not fill fuel tank while snow thrower is

running, when it is hot, or when snow thrower is in an enclosed area.

Keep away from open flame or an electrical spark and Do Not Smoke while filling the fuel tank.

Never fill the tank completely. Fill the tank to within 1/4" - 1/2" from the top to provide

space for expansion of fuel.

Always fill fuel tank outdoors and use a fun- nel or spout to prevent spilling.

Make sure to wipe up any spilled fuel before starting the engine.

Store gasoline in a clean, approved con- tainer and keep the cap in place on the con- tainer.

TO START ENGINE (Recoil Starter)

Be sure that the engine has sufficient oil The snowthrewer engine is equipped with a recoil starter. Before starting the engine, be certain that you have read the follow- ing information:

COLD START (See figure above)

Be sure the auger drive lever is in the dis- engaged (Released) position.

Move the throttle control to "_P (Fast) po- sition.

Remove the keys from the plastic bag. In- sert one key into the ignition slot. Be sure it snaps into place. Do not turn key. Keep the second key in a safe place.

Rotate the choke control to Hchoke ON position,

11

Page 11
Image 11
Craftsman 536,884,791 Primer Button, Three-hole, grounded 120 volt A.C, Receptacle, Primer button between primes, 50F