Parts packed separately in carton (not shown full size)
2 - Ignition Keys
(Attached to engine in plastic bag)
1 - Crank Assembly
1 - Snow Chute Assembly
,4k
CAUTION: Always wear safety glasses or eye shields while assembling snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1- Knife (to cut carton and plastic ties) 2- 1/2 inch wrenches (or adjustable
wrenches)
2- 9/16 inch wrenches (or adjustable wrenches)
2- 3/4 inch wrenches (or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Measuring tape or ruler
The figure below shows the snow thrower in the shipping position.
The figure to the right shows the snow thrower completely assembled.
Lower I ]andle
Clutch
Cable
Reference to the right or left hand side
of the snow thrower is from the operator's position behind the unit.
TO REMOVE SNOW THROWER
FROM CARTON
•Locate all parts packed separately (as
shown above) and remove from carton. NOTE: Place fuel stabilizer in a safe place until needed for storage.
Auger drive lever
Crank
Assembly
Chute
Deflector
Upper
Assembly
