![](/images/new-backgrounds/1097384/9738425x1.webp)
CAUTION: When removing or tightening the blade nut, always use the method shown in figure below. The holding wrench must always be positioned on the nut be- hind the cutting blade.
/_ CAUTION: Do not attempt to sharpen this blade. You could cause damage to the blade which could result in breakage and possible user or bystander injury.
To replace the blade, do the following:
•Disconnect spark plug wire.
•Remove the
figure below securing the blade to the drive shaft.
•Remove the blade.
IMPORTANT: Note the position of the
washer and the blade cutting edge to ensure proper re-assembly. The blade is marked THIS SIDE OUT.
•Position the replacement blade against the washer on the drive shaft and secure with flange nut. Be sure to tighten nut securely to 40-45 foot pounds.
•Reconnect the spark plug wire.
WARNING: Always wear gloves when working on blade, it is sharp.
Tightening
Wrench
Wrent
ut
Bla_e
CARBURETOR ADJUSTMENT
The carburetor has been
IMPORTANT: Never tamper with the
engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you think the
13