Craftsman 536.7975 Operation, TO STOP MIN8 TILLERICULTIVATOR, To Operate Min! Tiller/Cultivator

Models: 536.7975

1 20
Download 20 pages 1.57 Kb
Page 10
Image 10
OPERATION

OPERATION

,,i ,i H,,mH,,i,,i,,ii,,, ,NH

The operation of this mini titlertcultivator can result in foreign objects being thrown

!

into the eyes, which

can result

in severe eye damage Always wear'safety glasses

or eye shields while

operating

the mini tiller/cultivator.

We recommend standard safety glasses or Wide Vision Safety Mask for over your

glasses,

 

 

i ,,,m,i

m,m,,,l,,

i,, ii IN,,,

TO STOP MIN8 TILLERICULTIVATOR

@Release the throttle control to stop the tines

@Move the shut-off switch on the engine to the "OFF" position

TO OPERATE

MIN! TILLER/CULTIVATOR

OSet the depth stake/transport wheels assembly to the desired tilling position as follows:

@Remove the hairpin cotter from the clevis pin securing "the depth stake (see Figure 8) Remove the clevis pin and adjust the depth stake upward to dig shallower or downward to dig deeper Reinstall the clevis pin and hairpin cotter

@Start the engine, tilt the unit back on the depth stake until the tines are off the ground and squeeze the throttle control all the way up against the hand grip The engine is governor controlled and should be run at full throttle

@Graspthe handles firmly and slowiytiltthe unit forward to begin the tilling action

@As the tines begin to make contact with the ground, hold back on the handles so that the tines will dig and not ride forward over the ground Hold back until the tines dig into the soil.

@Ifthe tilled depth is too deep ortoo shallow, turn off the engine and reset the depth stake

@If depthstake is not controlling forward action, lower the depth stake If the unit is not going forward, raise the depth stake

i,i .................................

TATING TINES, ROTATING TINES CAN

I_ CAUTION: KEEP AWAY FROM THE RO" CAUSE INJURY.

,N i,,,,,,,,,,,

CAUTION: GASOLINE IS FLAMMABLE AND CAUTION MUST BE USED WHEN HANDLING OR STORING IT. DO NOT

FILL FUEL TANK WHILE MINI TILLER/CU LTIVA- TOR IS RUNNING, HOT, OR WHEN MINI TILLER/ CULTIVATOR IS IN AN ENCLOSED AREA. KEEP AWAY FROM OPEN FLAME, ELECTRICAL SPARK, AND DO NOT SMOKE WHILE MIXING

FUEL OR FILLING THE FUEL TANK. NEVER FILL FUEL TANK COMPLETELY; BUT FILL THE TANK TO WITHIN t/4 - 1/2 INCH FROM THE TOP TO PROVIDE SPACE FOR EXPANSION OF FUEL.

ALWAYS FILL FUEL TANK OUTDOORS AND USE A FU NNEL OR SPOUT TO PREVENT SPILL- ING. MAKE SURE TO WIPE UP ANY SPILLED FUEL BEFORE STARTING THE ENGINE.

STORE GASOLINE IN A CLEAN, APPROVED CONTAINER, AND KEEP THE CAP IN PLACE ON THE CONTAINER. KEEP GASOLINE IN A COOL, WELL VENTILATED PLACE; NEVER IN THE HOUSE. NEVER BUY MORE THAN A 30 DAY SUPPLY OF GASOLINE TO ASSURE VOLATIL- ITY. GASOLINE IS INTENDED TO BE USED AS A FUEL FOR INTERNAL COMBUSTION ENGINES; THEREFORE, DO NOT USE GASOLINE FOR ANY OTHER PURPOSE_ SINCE MANY CHIL- DREN LIKE THE SMELL OF GASOLINE, KEEP IT OUT OF THEIR REACH BECAUSE THE FUMES ARE DANGEROUS TO INHALE, AS WELL AS BEING EXPLOSIVE.,

BEFORE STARTING ENGINE

FILL GAS

The two cycle engine used on this mini tilter/cultivator requires a mixture of gasoline and oil for lubrication of the bearings and other moving parts The correct fuel mixture ratio is 24:1 (see Fuel Mixtu_e Chart) Gasoline and oil must be premixed in a clean gasoline container Always use fresh, clean unleaded gasoline

WARNING: Experience indicates thai alcohol blended fuels (called gasahol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage Acidic gas can damage the fuel system of an engine while in storage To avoid engine problems, the fuel system should be emptied before storage for 30 days or longer. Drain the gas tank, start

10

Page 10
Image 10
Craftsman 536.7975 Operation, TO STOP MIN8 TILLERICULTIVATOR, To Operate Min! Tiller/Cultivator, Before Starting Engine