Craftsman 536.88113 Positionspeedselectorlever as, Plastic Tie Control Panel

3. Positionspeedselectorlever as-

sembly as shown in Figure 11.

4.Reinstall bolt, spring, washer and Iocknut See Figure 12.

5.Tighten Iocknut until 1/8 to 3/16 inch of the bolt threads protrude pas the

Iocknut.

6.Thread the 3/8-16" hex jam nut onto the lever until the nut reaches the end of the thread. See

Figure 12.

7.Thread the plastic knob as far as possible and ensure that the knob points forward.

8.Tighten the 3/8-16" hexjam nut against the knob securely.

9.Move shifter through all speeds to ensure proper tension of the spring. If shifter lever sticks in any of the

notches, loosen Iocknut 1/2 turn at a time until shifter lever moves more

freely.

10.If adjustment of speed of snow blower is needed, refer to "Friction

Wheel Adjustment" in the ADJUST- MENT/REPAIR section.

Shifter

Bracket

Plastic

Tie

Figure 10

Control

Panel

Figure 11

F-OOIO60J 10