Craftsman 536.88113 Product Specifications, Snow Thrower, AS Required, LUBRICATION-EVERY 25 Hours

PRODUCT SPECIFICATIONS

HORSEPOWER	11.0	HP
DISPLACEMENT	21.82	cu,	in.
GASOLINE	4 quads
CAPACITY	(unleaded)
OIL CAPACITY	5W30
(20 oz capacity)
;PARK PLUG:	Champion		RJ19LM
	(Gap	.030	in.)	or
	equivalent
VALVE CLEARANCE: Intake: .010 In,
	Exhaust:		.010	In.

prevent rubber friction wheel con- tacting the drive disc plate.

6.To grease zerk, use a hand grease gun, lubricate with a Hi Temp EP Moly grease. Fill zerk only until grease becomes visible below bear-

ing assembly located under grease zerk. DO NOT over fill.

CAUTION: DO NOT allow grease to come in contract with the disc drive

plate or friction wheel or damage will result.

IMPORTANT: Remove coin and en- sure that a gap exists between friction wheel and disc drive plate.

NOTE: Clean all excess grease found on friction disc hub.

SNOW THROWER

Sprockets

Hex Shaft and Sprockets

AS REQUIRED

The following adjustment should be preformed more than once each sea- son.

I.Auger drivebeltshould be adjusted afterthefirst2 to 4 hoursof use, againabout mid-seasonand twice each season thereafter(See to Ad- justBelts paragraph in the Ser- vice and Adjustment section).

LUBRICATION-EVERY 25 HOURS

Lubricate Disc Drive Plate every twenty-five (25) hours and at the end of the season and/or before storage.

To Lubricate

1.Position speed selector lever in first gear,

2, Stand the snow thrower up on the auger housing end.

3.Remove the bottom panel,

4.Turn disc drive plate clockwise by hand until grease zerk is clearly visible at front center. See

Figure 20.

5, Place a coin or (a shim of equal thickness) between the rubber fric- tion wheel and disc drive plate to

F-OOIO60J

(Require No

Lubrication

Friction

Disc

Drive

Plate

Friction
Wheel		Point at which
y.,,_oin	or Shim	be visible
		grease should

Gap Between

Friction Wheel

and Disc Drive

/Plate

Grease Zerk Figure 20

LUBRICATION-NOT REQUIRED

1, Hex Shaft and Sprockets - Hex shaft and sprockets require no lu- brication, All bearings and bushings are lifetime lubricated and require no maintenance. See Figure 20.

NOTE: Any greasing or oiling of the above components can cause contami- nation of the friction wheel. If the disc

19