![](/images/new-backgrounds/1112315/11231553x1.webp)
isengagedwithbothbearing platesandthatthewashersandre- tainingringareinstalledtheorigi-
nalpositionSeeFigure36. .
12,Fastenthebearingplatesusing
thefourboltsremovedearlier.
13.Make sure the hex shaft turns free- ly.
t 4. Check the adjustment of the friction
wheel. See "How To Adjust The
Friction Wheel" in this section.
15.Make sure the friction wheel and the
disc drive plate are free from grease or oil.
16.Install the bottom panel. See Figure 32.
17.Tighten the bottom bolts on each side of the bottom panel.
18.Install the top bolts on each side of the bottom panel.
19.Connect the spark plug wire,
HOWTO REPLACE THE AUGER SHEAR BOLT
The augers are secured to the auger shaft with special shear bolts. These shear bolts are designed to break and protect the ma- chine if an object becomes lodged in the au- ger housing. Do not use e harder bolt as the protection provided by the shear bolt will be lost.
,_ WARNING: For safety and to protect the machine, use only original equipment shear bolts.
To replace a broken shear bolt, proceed
as follows. Extra shear bolts were pro-
vided in the assembly parts bag.
1.Move the throttlecontrolto the stop position.Disengage all controls,
2.Disconnect the spark plug wire. Make sure aH moving parts have stopped.
3.Align the hole in the auger with the
hole in the auger shaft. Install the
new shear pin and spacer. See
Figure 37.
4.Connect the spark plug wire.
/S!elar Pin
ar
_Figure 37
TO ADJUST THE CARBURETOR
If you think your carburetor needs ad- justing, see your nearest Craftsman
Store. Engine performance should not be affected at altitudes up to 7,000 feet.
For operation at higher elevations, con- tact your nearest Craftsman Store.
IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed.
TO ADJUST OR REPLACE THE SPARK PLUG
NOTE: This spark ignition system
meets all requirements of the Canadian
NOTE: This engine complies with all current Australian and New Zealand
limitations regarding electromagnetic interference.
If you have difficulty starting the snow thrower, adjust or replace the spark plug. Replace the spark plug is the electrodes are pitted or burned or if the porcelain is cracked. Follow the instruc- tions below.
27