17.Disengage power to the auger/impeller
when snow thrower is transportedor not in use.
18.Use only attachments and accessories approved by the manufacturer of the snow thrower (such as tire chains, electric start kits, etc).
19.Never operate the snow thrower without good visibility or light. Always be sure of your footing, and keep a firm hold on the handles. Walk; never run.
MAINTENANCE AND STORAGE
1.Check shear bolts and other bolts
frequently for proper tightness to be sure the snow thrower is in safe working condition.
2.Never store the snow thrower with fuel
in the fuel tank inside a building where ignition sources are present such as hot water and space heaters, clothes dryers, and the like. Allow the engine
to cool before stodng in any enclosure.
3.Always refer to operator's manual instructions for important details if the snow thrower is to be stored for an extended pedod.
Contents of Parts Bag
1- Owner'sManual (not shown)
1 - Parts Bag (not shown)
!- Packet of Fuel Stabilizer (not shown) Non Assembly parts are found in toolbox
located on top of belt cover. 1 - Warranty Card (not shown)
•2 - Spare Shear Bolts
•2- Spare Shear Nuts
4.Maintain or replace safety and instruc- tion labels, as necessary.
5.Run the snow thrower a few minutes after throwing snow to prevent freeze- up of the auger/impeller.
Z_ WARNING: This snow thrower is for use on sidewalks, driveways and other ground level surfaces.
Caution should be exercised while using on
steep sloping surfaces. DO NOT USE SNOW THROWER ON SURFACES
ABOVE GROUND LEVEL such as roofs of
residences, garages, porches or other such structures or buildings.
© ©
1 _/8 In. | 1 - 3/8 In. |
Flatwasher | Lockwasher |
|
1- 3/8 In. Hex Nut
@©
1 - Starter Motor Cord | 2- Shifter Knobs |
2 -
4
