[.,,."_o,,_ V_ZIIB]P'_"_
HOW TO REMOVE
THE SNOW HOOD
To access the spark plug, the snow hood must be removed as follows:
1.Remove the choke control knob (see Figure 21).
2.Remove the safety key.
3.Remove the mounting screws (see Figure 22).
4.Slowly remove the snow hood. Make sure that the primer button
hose and the ignition wire are not disconnected.
5.The spark plug can now be ac- cessed.
6.To install the snow hood, first make sure that the primer button hose and the ignition wire are connected.
7.Mount the snow hood to the engine and secure with the mounting screws (see Figure 22).
8.Connect the choke control knob with the choke shaft on the carbure-
tor (see Figure 23 and Figure 24). Make sure the choke control knob is
properly installed. If the choke con- trol knob is not installed correctly, the choke will not operate.
9.Install the safety key.
Choke
Contro
Mounting Screws
Snow Hood
Spark
Plug
Hose
gure 22
Choke
Control Knob
Choke Shaft
Figure 23
Safety Key
Figure 21 | Carburetor |
Figure 24 |
F 0410108L | 22 |
