[.,,."_o,,_ V_ZIIB]P'_"_
11. | Remove | the three fasteners | that | ||
| hold the friction wheel to the hub | ||||
| (see Figure 43). |
|
| ||
12. | Remove | the friction | wheel | from the | |
| hub. Slip the friction wheel off the | ||||
| hex shaft, |
|
| ||
13. | Assemble | the new friction | wheel | ||
| onto hub with the fasteners re- | ||||
| moved | earlier. |
|
| |
14. | Install | the hex shaft | and bearings | ||
| with the four bolts removed earlier | ||||
| (see Figure 44). |
|
| ||
17.Check the adjustment of the friction wheel. See "How To Adjust The Friction Wheel" in this section.
18.Make sure the friction wheel and the
disc drive plate are free from grease or oil.
19.Install the bottom panel (see Figure 40).
20.Tighten the bolts on each side of the bottom panel.
21.Install the right wheel to the axle with the fasteners removed earlier.
22.Connect the spark plug wire.
Make sure the washers are | prop- |
erly installed in the original | posi- |
Fasteners
Friction
tion. Also, make sure the two | |
washers | are properly aligned |
with the | actuator arms. |
15. Make sure the hex shaft turns free- | |
ly. |
|
16. Install the left wheel, axle, and | |
drive sprocket with the fasteners | |
removed earlier. Install the chain | |
onto the drive sprocket (see | |
Figure 41). | |
Actuator Arms
Bearings
\
Washer
_, Hub Wheel
Hex Shaft
Fasteners
Figure 43
//_Washer
Bearings
/
Washer
I / | Washer |
Figure 44
F 0410108L | 31 |
