[o_o)_l
TO REMOVE SNOW FROM AUGER
to remove snow or debris
AARNING: Do not attempt that may become lodged in
auger with your hands. Use the
cleaning stick to remove snow or debris.
A cleaning stick is attached to the top of the auger housing. Use the cleaning
stick to remove snow from the auger housing.
•Release auger drive lever.
•Remove (do not turn) safety key.
•Disconnect spark plug wire.
•Do not place your hands in the au- ger or discharge chute. Use the cleaning stick to remove snow.
SNOW THROWING TIPS
1.For maximum snow thrower efficien- cy in removing snow, adjust ground speed. Go slower in deep, freezing or wet snow. If the wheels slips, re- duce forward speed.
2.Most efficient snow throwing is ac- complished when the snow is re- moved immediately after if falls.
3.For complete snow removal, slightly overlap each path previously taken.
4.The snow should be discharged down wind whenever possible.
5.For normal usage, set the skids so that the scraper bar is 1/8" above the skids. For extremely hard- packed snow surfaces, adjust the skids upward so that the scraper bar touches the ground.
6.On gravel or crushed rock surfaces,
set the skids at
picked up and thrown by the ma- chine.
After the snow throwing job has been completed, allow the engine to idle for a few minutes, which will melt snow and accumulated ice off
the engine.
8.Clean the snow thrower thoroughly after each use.
9.Remove ice and snow accumulation and all debris from the entire snow thrower, and flush with water (if pos- sible) to remove all salt or other chemicals. Wipe snow thrower dry.
F 0410108L | 17 |
