Craftsman 536.8884 manual _ CAUTION: Never run engine indoors

Models: 536.8884

1 42
Download 42 pages 25.15 Kb
Page 14
Image 14
,/_ CAUTION: Never run engine indoors

,/_ CAUTION: Never run engine indoors

.or'_ienclosed, poody vantilated areas. En- gine exhaust contains CARBON MONOX-

IDE, AN ODORLESS AND DEADLY GAS. Keep hands, feet, hair and loose clothing away from any moving parts on engine and snow thrower.

WARNING: Temperature of muffler and nearby areas may exceed 150 ° F. Avoid these areas.

DO NOT allow children or young teenagers to operate or be near snow thrower while it is operating.

A_ CAUTION: Do no attempt to remove

any item that may become lodged in auger without taking the following precautions:

Release auger drive and traction drive levers.

Move throttle lever tO stop position.

Remove (DO NOT TURN) ignition key.

Disconnect spark plug wire.

Do not place your hands in the auger or discharge chute. Use a pry bar.

SNOW THROWING TIPS

For maximum snow thrower efficiency in removing snow, adjust ground speed, NEVER the throttle. Go slower in deep, freezing, or wet snow. If the tracks slip, re- duce forward speed. The engine is

designed to deliver maximum perfor- mance at full throttle and should be run at

this power setting at all times. Most effi- cient snow blowing is accomplished when the snow is removed immediately after it falls.

For complete snow removal, slightly over- lap each path previously taken. Usa more overlap in deep snow to prevent overload- ing.

The snow should be discharged down wind whenever possible. In windy condi- tions, lower the chute deflector to direct discharged snow close to the ground,

where it is less likely to blow into un- wanted areas.

For normal usage, set the skids so that the scraper bar is 1/8' above the skids, For extremely hard-packed snow surfaces, adjust the skids upward so that the scraper bar touches the ground.

On gravel or crushed rock surfaces, set the skids at 1-1/4" below the scraper bar (See To Adjust Skids Height paragraph on page 17). Stones and gravel must not be picked up and thrown by the machine.

After the snow throwing job has been completed, allow the engine to idle for a few minutes, which will melt snow and accumulated ice off the engine.

*Clean the snow thrower thoroughly after

each use... _"

. Remove ice and snow accumulation and all debris from the entire snow thrower, and flush with water (if possible) to re- move all salt or other chemicals. Wipe

snow thrower dry.

 

 

 

PRODUCT

SPECIFICATIONS

 

HORSE POWER:

6HP

 

DISPLACEMENT:

11.88 cu. in.

GASOLINE

CAPACITY:

4 quart

 

 

 

 

(unleaded)

OIL (20 oz. Capacity)

:

5W-30

 

SPARK PLUG:

Champion

RC19LM

 

 

(Gap .030)

or

 

 

Equivalent

 

VALVE CLEARANCE: intake: .010 In.

Exhaust: .010 In.

t4

Page 14
Image 14
Craftsman 536.8884 manual _ CAUTION: Never run engine indoors