17.Disengage power to the auged impeller when snow thrower is transported or not in use.

18.Use only attachments and accesso- ries approved by the manufacturer of the snow thrower (such as tire chains, electric start kits, etc).

19.Never operate the snow thrower without good visibility or light. Always be sure of your footing, and

keep a firm hold on the handles. Walk; never run.

MAINTENANCE AND STORAGE

1.Check shear bolts and other bolts

frequently for proper tightness to be sure the snow thrower =s in safe

working condition.

2.Never store the snow thrower with fuel in the fuel tank inside a

building where ignition sources are present such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure.

3.Always refer to operator's manual

instructions for important details if the snow thrower is to be stored for an extended period.

Contents of Parts Bag (actual size)

1 - Owner'sManual (not shown)

2 - Parts Bags (not shown)

*Non-Assembly Parts ere found In the toolbox located on top of the bett cover

4.Maintain or replace safety and instruc- tion labels, as necessary.

5.Run the snow thrower a few minutes after throwing snow to prevent freeze- up of the auger/impeller.

A

/_ WARNING: This snow thrower is for use on sidewalks, driveways and other

ground level surfaces. _.

Caution should be exemi_ed while using on

steep sloping surfaces. DO NOT USE SNOW THROWER ON SURFACES

ABOVE GROUND LEVEL such as roofs of

residences, garages, porches or other such structures or buildings.

*2 - Spare Spacers

3 - Carriage Bolts,

5/16-18xl.00 In.

3 -Hex Nylon Nuts,

5 - 11/32 Flatwashers 5/16-18

*2 - Spare Shear Pine

1- Shifter Knob

1- Nut, 1/2-13 Hexlam

1 - Starter Motor Cord 10Ft.

L

Page 4
Image 4
Craftsman 536.8884 manual Maintenance and Storage