| © | B© |
2 | 2- Nut, | |
Pads | , in carton (not shown full size) |
|
2 - Ignition Keys | 1 - container 5W30 oil | |
{Attached to engine in | ||
1 - Snow Chute Assembly | ||
plastic bag) |
|
THIS SNOW THROWER HAS A TRACK DRIVE SYSTEM EQUIPPED TO GIVE YOU
If your snow thrower must be moved without the aid of the engine, it will be easier to pull the snow thrower backward by the handles rather than pushing. For details on how to use
the
On start up, the track drive system may be ti_ghtbut wilt loosen up as the snow thrower is used. After first use, check the track for tension and adjust if necessary. See the Track
Adjustment paragraph in the Service and Adjustments section of this manual. Check track adjustment and fasteners regularly.
Z_ | CAUTION: Always wear safety | The figure below shows the snow | thrower | ||
glasses or eye shields while assembling | completely | assembled. |
| ||
References | to the right or left hand | side | |||
snow | thrower. | ||||
TOOLS REQUIRED FOR ASSEMBLY
of the snow thrower are from the viewpoint of the operator'sposition behind the unit.
1 - Knife to cut carton and plasticties
2 - 1/2 inchwrenches (or adjustable wrenches)
2- 9116 inch wrenches (or adjustable wrenches)
2 - 3/4 inchwrenches (or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1- Screwdriver
1 - Measuring tape or ruler
Auger ( | drive lever |
|
Chute deflector
lever
The figure below shows the snow thrower in
the shipping carton.
plate
Clutch
handleadjustskids
essemb_j
5
