Craftsman 536.8884 manual Unit fails to propel itself

TROIJBLE			CAUSE	CORRECTION
Difficult	starting		Defective spark plug	Replace defective plug
			Water or dirt in fuel system	Use carburetor bowl drain to
				flush and refill with fresh fuel
Engine	runs	er-	Blocked fuel line or low on fuel	Clean fuel line; check fuel sup-
ratlcally				ply; add fresh gasoline (gaso-
				line/oil mixture if 2-cycle engine)
Engine	stalls		Unit running on CHOKE	Move choke lever to OFF position
Engine	runs	er-	Water or dirt in fuel system	Use carburetor bowl drain to
ratlcally;				flush and refill with fresh fuel
or

Loss of power

Excessive vibration

Unit fails to propel itself

Unit fails to discharge snow

Loose parts; damaged impeller

Ddve belt loose or damaged

Incorrect adjustment of auger con- lrol cable

_/om or damaged friction wheel

Auger drive belt loose or damaged

Auger control cable not adjusted correctly

Shear bolt broken

Discharge chute clogged

Stop engine immediately and disconnect spark plug wire. Tighten all bolts and make all necessary repairs, If vibration continues, have the unit ser- viced by a Craftsman service

repairman

Replace drive belt

i Adjust traction drive cable

i Repair frict on wheel

Adjust auger drive belt; replace if damaged

Adjust auger control cable

Replace shear bolt.

e

Stop engine immediately and dis- connect spark plug wire. Clean discharge chute and inside of au- ger housing

Unit rides up

Foreign object lodged in auger

Weight transfer disengaged

Stop engine immediately and dis- connect spark plug wire. Remove object from auger.

Engage weight transfer system by lifting up on upper handle until bracket bolts snap into place in upper slots of weight transfer _edal.

24