CARTON CONTENTS
The followingparts are shipped loose with your pressure washer. Before assembling, become familiar with each piece.
Check all carton contents against the listing below:
Main Unit:
•PressureWasher (w/wheels) and Guide Handle.
•High Pressure Hose
Parts Box:
•Adjustable Nozzle
•Turbo Nozzle
•Spray Gun
•Nozzle Extension
•Wire Form
•Motor Oil
Manual Bag:
•Owner'sManual
•Nozzle Cleaning Kit
•"O"-Ring Kit
If any parts are missing or damaged, call the Pressure Washer Helpline at
HOW TO REMOVE THE HIGH PRESSURE WASHER FROM CARTON
Remove parts boxes included with pressure washer.
The high pressure hose is packed in the bottom of the carton. Remove the hose.
Slice two comers at handle end of carton, from top to bottom, so the panel can be folded down flat.
Raise handle, secure in place with the locking caps (refer to illustration below) and roll the pressure washer out the open end of the carton.
Locking Caps
HOW TO SET UP YOUR PRESSURE WASHER
For the most part, your Craftsman High PressureWasher has been assembled at the factory. You must, however, attach the wire form, assemble the spray gun and attach the high pressurehose to the pump and spray gun.
•While facing the rear of the Pressure Washer, insert
the wire support with the longer arm positioned on the left. From this view the hook should resemble a "J'.
•Cut tie wrap on chemical injectiontube. Remove the chemical injection filter, thread chemical injectiontube through the wire form.
Reinsert the chemical injectionfilter into tube.
•Check carton for additionalloose parts.
