NOTE:Lineglideplatemustberein- stalledincuttingheadbeforeinserting newline.
4.Insertbothendsofyourline throughtheproperholesinthe sideofthecuttinghead.
!
Positioning
Tunnel
6.Correctly installed line will be the same length on both ends.
REPLACING THE CUTTING HEAD
1.Align hole in tile dust cup with tile hole in the side of the gearbox by rotating the dust cup.
2.Insert a small screwdriver into
aligned holes. This will keep the shaft from turning while removing and installing trimmer head.
Ssrew ,er
5, Pull the line and make sure the
line is against the hub and ex-
tended full through the positioning tunnels.
Line against
Positioning
Tunnel \
3.While holding the screwdriver in position, remove trimmer head by turning clockwise.
4.Thread replacement trimmer head onto the shaft by turning counterclock- wise. Only tighten hand tightt
5.Remove the screwdriver.
BLADE REPLACEMENT
Refer to the ASSEMBLY section for
blade replacement instructions and il- lustrations=
A
411 WARNING: Perform the following steps after each use:
•Allow attachment and gearbox to cool before storing or transporting.
•Store attachment with blade shield in
place. Position attachment so that any sharp object cannot accidentally cause injury.
•Store the attachment in a dry, well ventilated area out of the reach of children.
SEASONAL STORAGE
Prepare attachment for storage at end of season or if it will not be used for 30
days or more.
If your brushcutter attachment is to be stored for a period of time:
•Clean the entire attachment.
•Inspect the blade shield area and clean any dirt, grass, leaves, or de- bris that has collected. Inspect the blade and blade shield; replace a blade that is bent, warped, cracked, broken or damaged in any other way.
•Lightly oil external metal surfaces.
•Apply a coating of oil to the entire surface of the blade; wrap it in heavy paper or cloth.
•Check entire attachment for loose
screws or nuts= Replace any dam- aged, worn or broken parts.
•At the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.
15
