NOTE:Thedustcupandretaining | NOTE: | Make | sure | all parts are in place | ||||
washerarelocatedonthegearboxshaft | as | illustrated, | and the blade is sand- | |||||
andnotinthepartsbagAllotherfas.- | wiched | between the dust cup and the | ||||||
tenersmentionedinthefollowingas- | retaining | washer. There should | be no | |||||
semblystepsareinthepartsbag. | space between the | blade and | the dust | |||||
1. | Removetheretainingwasherfrom | cup or the | retaining | washer. |
| |||
| thethreadedshaftofthegearbox. | 7. | Align | hole | in dust cup with | hole in | ||
2. | Leavethedustcupontheshaft. |
| side | of gearbox | by rotating | the | ||
Installthebladeandtheretaining |
| blade. |
|
|
|
| ||
| washeroverthethreadedshaft. | 8. | Insert | a small | screwdriver | into | ||
3.Makesuretheraisedpartofthere- aligned holes. This will keep the tainingwasherisfacingthegearbox shaft from turning while tightening andtheraisedareafitsintothehole the blade nut. inthecenteroftheblade.
4.Slidethebladeandretainingwasher ontotheshaftofthegearbox.
5.Placethecuppedwasherontothe Screwdriver _ shaftMakesurethecuppedside. ofthewasheristowardtheblade.
6.Installthebladenutbythreading ontotheshaftcounterclockwise.
| Gearbox | 9. | Tighten | blade nut firmly | with a | |
|
| wrench | while | holding screwdriver | ||
|
|
| ||||
|
|
| in position. |
|
| |
Shield |
| 10. | Remove | the | screwdriver. |
|
Dust Cup
de
Retaining pE_lt_,_..
Washer _
Cupped
Washer
_Nut
11.Turn blade by hand. If the blade binds against the shield, or appears to be uneven, the blade is not cen-
tered, and you must reinstall. NOTE: To remove blade, insert screw- driver into aligned holes. Unthread the nut and remove parts. Be sure to store parts and instructions for future use.
