•The guard must be installed before
trimming or edging - if not, the motor will overheat.
•When replacing the line, use .065" diameter ROUND line - otherwise the
unit may not function properly.
•Angle tool slightly (5 ° to 10") when trimming.
DOUBLE INSULATION
Double insulated tools are constructed
throughout with two separate layers of electrical insulation or one double
thickness of insulation between you and the tool'selectdcal system. Tools built with this insulation system are not intended to be grounded. As a result,
your tool is equipped with a two prong plug which permits you to usa extension
cords without concern for maintaining a ground connection.
NOTE: Double insulation does not take the place of normal safety predautions when operating this tool. The insulation system is for added protection agaihst injury resulting from a possible electrical insulation failure within the tool.
REPLACEMENT PARTS: When
servicing all tools, USE IDENTICAL
REPLACEMENT PARTS.
POLARIZED PLUGS
Repair or replace damaged cords.
To reduce the dsk of electric shock, this equipment has a polarized plug (one blade is wider than the other). This equipment must be used with a suitable polarized 2 wire or 3 wire extension cord. Polarized connections will fit together only one way. Make sure that the
ATTACHING THE GUARD AND EDGE GUIDE TO THE TRIMMER/EDGER
&WARNING: The guard must always be on the tool to protect the user. NEVER OPERATE TOOL WITHOUT GUARD
FIRMLY IN PLACE.
Unplug the tool before attempting to attach the guard.
1.Spread the edge guide apart and locate it in the slot and hole as shown in Figure 1.
2.See Figure 2 for edge guide assembled on the trimmer.
•Always use the cord retainer.
•Wear long pants and substantial footwear to protect yourself from injury
caused by flying debds. This is especially important when edging with the appliance.
receptacle end of the extension cord has large and small blade slot widths. If the plug does not fit fully into the extension cord, reverse the plug. If it still does not fit, obtain a suitable extension cord. If the extension cord does not fit fully into the
the tool plug or extension cord in any way.
SPECIFIC WARNING
&WARNING: Some dust created by this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm
•-.•
Some examples of these chemicals are:
•compounds in fertilizers
•compounds in insecticides, herbicides and pesticides
•arsenic and chromium from
chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety equipment such as dust masks that are specially designed to filter out microscopic
particles.
t, WARNING: This product contains chemicals, including lead, known to the
State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.
3.Slip the guard onto the trimmer
housing and line up screw holes+ Make sure that it fits onto the
mounting shoulder and that the
locking tabs on the guard fit into the two notches on the housing, as
shown in Figure 3.
4.Insert the two screws from the plastic bag to secure the guard and edge guide in place as shown in Figure 4.
5.Attach extension cord to cord retainer as shown in Figures 5 & 6.
4
