REWINDING SPOOL |
|
Use .065" diameter ROUND line only. Do |
|
not use heavier gauge line; it will |
|
overload motor and cause overheating. |
|
1. Insert line end about 118" into the |
|
spool hole as shown in Figures 15 |
|
and 16. |
|
2. Snugly and evenly wind the line onto | INSERTLINEHERE |
the spool in the direction of the arrow |
|
on the spool until the line builds up to |
|
the notches in the spool rim (Figure |
|
17). Do not overfill spool. The spool |
|
holds about 20 feet of line. |
|
3. Proceed to step 5 of =Spool or Line |
|
Replacement". |
|
CLEANING AND STORAGE
Be sure the tool is unplugged.
1.Keep the air intake slots (Figure 18) clean to avoid overheating.
2.Your trimmer line can dry out oyer
time. To keep your line in top condition, store spare
3.Plastic parts may be cleaned by using a mild soap and a damp rag.
4.DO NOT immerse tool in water or squirt it with a hose. DO NOT allow any liquid to get inside it.
5.Do not store the tool on or adjacent to fertilizers or chemicals.
6.DO NOT clean with a pressure washer.
7.The line cutter on the edge of the guard can dull over time. It is recommended you periodically
Conversion Button
Air Intake Slots
ACCESSORIES
•Replacement spool, Craftsman Model No. 85680.
•0,065" diamter ROUND nylon monofilament trimmer line.
The above accesspry is available at your local Sears store or Sears service center.
A, WARNING: The use of any accessory
not sold by Sears for use with this tool could be hazardous.
IMPORTANT: To assure product SAFETY AND RELIABILITY, repairs should be performed by a Sears or other
qualified service facility, using only identical replacement parts.
7
