
COMSPHERE 392xPlus Modems
Messages listed in Table
| Table | |
| Common Operational Messages | |
|
| |
Common | Indicates | |
Operational Message | ||
| ||
|
| |
Please Wait... | A command to a local device takes more than two seconds to complete. | |
|
| |
Command Sent... | A command is sent to a remote modem. | |
|
| |
No Rem Response or | A remote modem does not respond to a command within 5 seconds. | |
Remote Modem Fail |
| |
|
| |
Command Complete | A command, issued to a local or remote modem, is completed. | |
|
| |
Invalid Command | The modem cannot complete a command. | |
|
|
Messages listed in Table
| Table | |
| Dial Access Security Messages | |
|
| |
Dial Access | Indicates | |
Security Message | ||
| ||
|
| |
Get VF PsWd | The answering modem is waiting for the originating caller to transmit a VF password. | |
|
| |
Get DTE PsWd | The answering modem is waiting to receive a valid DTE password from the remote DTE. | |
|
| |
VF PsWd Timeout | The modem did not finish answering a call (disconnected) because the allowed time limit | |
| was exceeded before the modem received a VF password from the originating dialer. | |
|
| |
Unknown DTEpswd | The modem did not finish answering a call (disconnected) because the DTE passwords | |
| received from the remote DTE were invalid. | |
|
| |
No Orig PsWd | The modem did not attempt to establish a call as requested because the AT dial | |
| command did not contain an originate access password. | |
|
| |
Unknown VF PsWd | The modem did not finish answering a call (disconnected) because the modem received | |
| an invalid VF password. | |
|
| |
DTEpswd Timeout | The modem did not finish answering a call (disconnected) because the allowed time limit | |
| was exceeded before the modem received a DTE password from the remote DTE. | |
|
| |
Inval Orig PsWd | The modem did not attempt to establish the call as requested because the originate | |
| password in the AT dial command was not valid. | |
|
| |
DTR Dial Blocked | DTR dialing is not permitted when security is enabled. This message appears if DTR | |
| dialing is used and Answer Access or Originate Access security is enabled. | |
|
| |
SecurityBlocked | The access verification capabilities are not available and the modem does not pass data | |
| to the DTE under any circumstances. This message appears only when the modem is in | |
| base mode (a mode that occurs during a firmware download) and Answer Access | |
| Security is enabled. | |
|
|
November 1996 |