DCP Operation

Control:

Download_Code

F1 F2 F3

Press the key until Download_Code appears. Press any function key to select

Download_Code. The DwnLoadSoftware screen appears.

DwnLoadSoftware >

Clone_Remote

F1 F2 F3

Press any function key to select Clone_Remote.

The next screen to appear is determined by the modem's configuration. Refer to the appropriate section based on your modem's configuration; Clone Remote in Point-to-Point Configurations, Clone Remote in Broadcast Configurations, or Clone Remote in Multipoint Configuration.

Clone Remote in Point-to-Point Configurations

Before using Clone Remote in point-to-point configurations, verify the following:

The 392xPlus modems have an established leased-line connection using either V.34 family, V.33, V.32 family, or V.29 modulation (refer to the Leased Line section in Chapter 4) or a dial network connection using either V.34 family or V.32 family modulations (refer to the Dial Line section in Chapter 4).

The remote modem's Access From Remote configuration option is enabled (refer to the Misc section in Chapter 4).

The password (Remote Access Password configuration option) is the same in both the local and remote modems. (For an example of how to change the password, refer to the Editing and Saving a Configuration Option section in Chapter 4.)

After completing these checks, proceed to the section titled Implementing a Clone Remote

Operation, which follows the descriptions of multipoint cloning operations.

Clone Remote in Broadcast Configurations

A tributary modem configured for extended diagnostics (Diagnostic Connection configuration option set to Modem(DC)) can perform two types of Remote Clone operations. It can clone the upstream, VF connected, control modem (SC_Clone) or it can clone all the 392xPlus modems attached to its downstream Diagnostic Channel (DC_Broadcast).

Choose DLL Type >

SC_Clone

F1 F2 F3

3920-A2-GN31-30

November 1996

3-43

Page 80
Image 80
Paradyne 392xPLUS operation manual Control DownloadCode, DwnLoadSoftware CloneRemote, Choose DLL Type SCClone