Paradyne 392xPLUS EchoFreqOff, Phase Hts, Impul Hts, DropOuts, Retrains, Phas Jtr, NonLinear

COMSPHERE 392xPlus Modems

EchoFreqOff	Echo Frequency Offset displays the frequency offset of the far end echo. This
	parameter appears for V.34, V.32 terbo, V.32bis, and V.32 modulations (in
	2-wire only).
Phase Hts	Phase Hits reports the total hit count of sudden uncontrolled changes in the
	phase of the receive signal for the past 15 minutes. This parameter appears for
	V.32 terbo, V.32bis, and V.32 modulations (in 4-wire only).
Impul Hts	Impulse Hits reports the total hit count of large burst or spikes that are larger
	than normal peaks of random white noise for the past 15 minutes. This
	parameter appears for V.32 terbo, V.32bis, and V.32 modulations (in 4-wire
	only).
DropOuts	Drop Outs reports the total number of large reductions in channel gain for the
	past 15 minutes. This parameter appears for V.32 terbo, V.32bis, and V.32
	modulations (in 4-wire only).
Retrains	Retrains displays the number of retrains over the last 15 minutes of operation.
	The total 15-minute accumulation is updated every minute. This parameter
	appears for V.32 terbo, V.32bis, V.32, and Trellis Multipoint modulations (in
	4-wire only).
Phas Jtr	Phase Jitter is the non-constant variation in the phase of the receive signal
	carrier. The jitter is typically introduced by analog power supplies and is
	predominantly sign waves with a frequency of 50 Hz or 60 Hz. This parameter
	appears for V.32 terbo, V.32bis, and V.32 modulations (in 4-wire only).
NonLinear	Non-Linear Distortion displays distortion which is usually associated with
	pulse-code modulation (PCM) compandor noise on the phone line. This
	parameter appears for V.32 terbo, V.32bis, V.32, and Trellis Multipoint
	modulations (in 4-wire only).
FreqOffset	Frequency Offset reports the variation in all frequencies in the voice band. This
	parameter appears for V.32 terbo, V.32bis, and V.32 modulations (in 4-wire
	only).
Gain Hts	Gain Hit reports the total number of rapid changes in the receiver power level
	for the past 15 minutes. This parameter appears for V.32 terbo, V.32bis, and
	V.32 modulations (in 4-wire only).

Clearing VF Counters

The Clear command resets the retrain, impulse hits, gain hits, phase hits, and drop outs.

Status:VF

Display Clear

F1 F2 F3

To clear the VF counters, select Clear.

3-22 November 1996 3920-A2-GN31-30