Paradyne 392xPLUS Reset, Data Stream, Control DataStream, Select DS Port Port1 Port2

DCP Operation

Reset

Reset causes the modem to stop operation and perform a complete program restart. The modem begins the power-up test sequence that ends with the Top-Level menu displayed on the LCD. Configuration options stored in an Active (Saved) configuration area are copied to the Active (Operating) configuration area.

To access Reset from the Control branch, make the following selection:

Control:>

Speaker Reset

F1 F2 F3

Select Reset.

The message Reset appears momentarily before the modem performs the power-up diagnostic test sequence.

Data Stream

Use Data Stream to enable or disable the modem's data transmitter function on a specific port or on all ports.

The Data Stream function is not available in Async mode in Singleport mode.

To access Data Stream from the Control branch, make the following selections:

Control:

Data_Stream

F1 F2 F3

Press the

key until Data Stream appears. Select Data Stream (F1).

Select	DS Port	>
Port1		Port2
F1	F2	F3

If the mux is enabled, press the key to scroll the available ports into view. You may see Port1, Port2, Port3, Port4, or All. For information on selecting All, refer to Selecting All Ports later in this section.

To select a port, press the appropriate function key (F1 or F3).

This screen does not appear if in Singleport mode or the DTE Bridge configuration option is enabled.

Now go to the next screen (Data Stream).

3920-A2-GN31-30 November 1996 3-37