Paradyne 392xPLUS operation manual 392xPlus S-Registers Description

COMSPHERE 392xPlus Modems

Table 5-3

(1 of 12)

392xPlus S-Registers

S-Register	Description	DCP LCD
		Command
		Sequence
S0	Auto-Answer Ring Number1. Register determines number of rings the modem	Configure\Edit\
	will count before automatically answering a call.	Line Dialer
	Enter zero (0) if you do not want the modem to automatically answer any calls.
	Otherwise, enter a value from 1±255 for the number of rings to count before
	answering. The factory setting is 1.
S2	AT Escape Character. Register determines ASCII value used for escape	Configure\Edit\
	sequence to enter Command mode from Data mode.	DTE Dialer
	Enter a value from 0 to 127 for the escape character. Any value greater than
	127 causes the modem to disable the escape sequence. When the escape
	sequence is disabled, the modem cannot return to Command mode until the
	call is disconnected. The factory setting is 43 (+ key).
S3	Carriage Return Character. Register determines ASCII value used as the	Configure\Edit\
	carriage return (Return key). This character is used to end command lines and	DTE Dialer
	result codes.
	Enter a value from 0 to 127 for the command end character. The factory
	setting is 13 (carriage return key).
S4	Line Feed Character. Register determines ASCII value used as the line feed	Configure\Edit\
	character.	DTE Dialer
	Enter a value from 0±127 for the line feed character. The factory setting is 10
	(ASCII carriage return or line feed).
S5	Backspace Character. Register determines ASCII value used as the	Configure\Edit\
	backspace (Backspace key). This character moves the cursor to the left and	DTE Dialer
	erases the previous character.
	Enter a value from 0±127. The factory setting is 8 (backspace key).
S6	Blind Dial Pause1. Register determines how long (in seconds) the modem	Configure\Edit\
	waits after going off-hook before dialing a telephone number if using result	Line Dialer
	code X0, X1, or X3.
	Enter a value from 2±255 seconds. The factory setting is 2.
S7	No Answer Time-out1. Register determines how long (in seconds) an	Configure\Edit\
	originating modem waits before abandoning a call when no answer tone is	Line Dialer
	received.
	Enter a value from 1±255 seconds. The factory setting is 45.
S8	ª,º Pause Time for the Dial Modifier. Register determines how long (in	Configure\Edit\
	seconds) the modem pauses when it encounters a comma (,) in the Dial	Line Dialer
	command string.
	Enter a value from 0±255 seconds. The factory setting is 2.
S10	No Carrier Disconnect1. Register determines how long (in tenths of seconds)	Configure\Edit\
	the modem allows the carrier signal to be OFF before disconnecting the call.	Line Dialer
	Enter a value from 0±254 in 0.1 second increments. A value of 255 disables
	this register. The factory setting is 20 (2 seconds).

1 The range of allowable values may be restricted in some countries.

5-16 November 1996 3920-A2-GN31-30