COMSPHERE 392xPlus Modems
Network Management System Connection
Use the following steps to connect the modem to the network management system (NMS) interface:
1.Insert the
3600 Hubbing Device, Feature Number
2.Connect the 3600 Hubbing Device to the network management system (Figure
Removing and Replacing the Model 3920Plus Modem
To remove and replace the Model 3920Plus modem, perform the following steps:
1.Make sure the modem is offline. Press the modem's back panel power switch to OFF.
2.Disconnect the power cord from the ac power outlet.
3.Disconnect the dc power cable from the connector on the back of the modem.
4.Disconnect the
5.Disconnect the DTE interface cable(s) from the modem's back panel.
If the modem is to be removed for service, return it to the company using the procedures described in Government Requirements and Equipment Return in Chapter 1.
6.Install the replacement modem as described in the Model 3920Plus Modem Installation section of this chapter, and configure it the same way as the modem being replaced.
Model 3921Plus Modem Installation
CAUTION
When removing the Model 3921Plus from the carrier, always use a ground strap when handling the modem. Always store the Model 3921Plus in an antistatic bag when it is removed from the carrier.
The Model 3921Plus modems are designed for installation in a COMSPHERE 3000 Series Carrier, which supplies both the operating power and the leased and/or dial network connections. For additional information about the COMSPHERE 3000 Series Carrier, refer to the COMSPHERE 3000 Series Carrier, Installation Manual.
The COMSPHERE 3000 Series Carrier has 17 slots that hold up to 8 Model 3921Plus multiport modems or 16 Model 3921Plus singleport modems, and one shared diagnostic unit (SDU). The
November 1996 |