Paradyne 392xPLUS operation manual Dcp Lcd

COMSPHERE 392xPlus Modems

Table 5-2

(5 of 9)

392xPlus AT Commands

AT		Description	DCP LCD
			Command
Command
			Sequence
&Gn	V.22bis Guard Tone.		Configure\Edit\
	&G0	Disable.	Dial Line
	&G1	550 Hz.
	&G2	1800 Hz.
	NOTE: The V.22bis Guard Tone cannot be disabled in some countries.
&In	Dial Transmit Level.		Configure\Edit\
	The AT command is &In, where n is		Dial Line
	0 for ±0 dBm
	1 for ±1 dBm
	•
	•
	•
	32 for ±32 dBm
	NOTE: In North America the range of allowable values is ±10 dBm to ±32 dBm.
		This command is disabled in some countries (it answers OK but does not
		change the level).
&Ln	Leased Mode.		Configure\Edit\
	&L0	Disables leased-line operation.	Leased Line
	&L1	2-wire originate leased-line operation.
	&L2	4-wire originate leased-line operation.
	&L3	2-wire answer leased-line operation.
	&L4	4-wire answer leased-line operation.
	The &L command will cause the modem to reset before entering or exiting
	Leased Line mode. Therefore, it must be entered as the last command in an
	initialization string.

5-10 November 1996 3920-A2-GN31-30