COMSPHERE 392xPlus Modems
To disconnect the modem from the service line and resume normal operation, press the 
key
(returning to Control branch). From the Control branch, press the 
key until DiscServiceLine appears.
Control:
DiscServiceLine
F1 F2 F3
Press F1 (DiscServiceLine). The call and service line disconnect and the message Command Complete appears.
Download Software
The Download Software function sets parameters within the modem when transferring firmware to one or more modems or when receiving firmware upgrades from a locally attached
There are two selections under Download Software: Clone Remote and To Local via DTE. Clone Remote is used to transfer an exact copy of the firmware currently stored in a 392xPlus modem to either one or more remote 392xPlus modems or one or more
When implementing a Clone Remote operation, the following is true:
•The Clone Remote function only operates properly if the remote modems are connected to the local modem via a
•The Clone Remote will not appear on the LCD if the modem is not configured for leased lines and a
For more information on Clone Remote operation, refer to Implementing a Clone Remote
Operation later in this section.
The second selection appearing on the LCD is To Local via DTE. This function permits firmware upgrades to be transferred to a 392xPlus modem. This type of download requires a locally attached PC controller to be connected to the modem's DTE port as well as special download software. Any downloads using this selection are intended to be performed by service representatives only.
Selecting Clone Remote
NOTE
Clone Remote operations are not supported unless both local and remote modems are 392xPlus modems. (The 3800 or 391x Series modems cannot be used in cloning operations with 392xPlus modems.)
To access DwnLoadSoftware from the Control branch, make the following selections:
November 1996 |
