
DCP Configuration
Table
(5 of 5)
Leased Line Configuration OptionsÐ Singleport Mode A
V29 Link Config: PointToPoint
Nxt PointToPoint Multipoint
This configuration option only appears when
V.29 Link Configuration. Selects
NOTE: Remote mode and the Cloning function are not available when configured for V.29 multipoint. The AT command is
TMp Train Time: 50
Nxt 50 10 20 100 200 300
This configuration option only appears when
Trellis Multipoint (TMp) Train Time. Defines the length of time energy is sent from the tributary modem to the control modem. More severe line conditions require longer time selections.
The AT command is
TMp TxPreemphasis: Enable
Nxt Enable Disable
This configuration option only appears if
Trellis Multipoint (TMp) Transmit Preemphasis. Provides amplification for frequencies above the carrier frequency to compensate for high frequency line attenuation.
The AT command is
Lease Lookback: Disable
Nxt Disable Enable
Lease Lookback. While operating on backup lines, this configuration option allows the modem to test the primary
Dual_Leased_Ln: Disable
End Disable Enable
Dual Leased Line. Allows the
NOTE: Plug the leased line into the jack labeled DIAL on the rear panel of the modem (see Figure
NOTE: When the Dual Leased Line configuration option is changed, the modem will reset.
BackupLine Check: Disable
Nxt Disable Enable
This configuration option is only available when the Dual Leased Line device option is enabled and the V.34 is disabled in the LeaseLine Rate configuration option.
Backup Line Check. Tests the backup circuit for availability while the modem is operating on the primary
NOTE: In network applications where the modem is in backup mode and is connected to a modem other than the modem connected to the primary
November 1996 |