
DCP Configuration
DTE Dialer Ð Singleport Mode A
The DTE Dialer configuration options establish the
Table
Table
(1 of 5)
DTE Dialer Configuration Options Ð Singleport Mode A
DTE Dialer Type: Disable
Nxt Disable AT V25bis_Async V25bis_Bsync V25bis_HDLC DTR=Direct1 AT&T_Exclusv
Data Terminal Equipment Dialer Type. Identifies to the modem the type of dialing method and protocol used by the DTE.
Disable ± Disables any type of DTE dialing method. Dialing can only be performed using the DCP's Dial command or attached telephone.
AT ± Allows AT command protocol to be used as a method for entering commands and dialing when used in an asynchronous application. This is the only valid setting for
V.25bis Async ± Selects V.25bis Async as the dialing method and protocol used by the modem. The character length must be 7 data bits with even parity and 1 stop bit.
V.25bis Bisync ± Selects V.25bis Bisync as the dialing method and protocol used by the modem. This is also known as
V.25bis HDLC ± Selects V.25bis HDLC as the dialing method and protocol used by the modem. This is also known as
DTR=Direct1 ± Allows the modem to automatically dial the number stored in directory location 1 whenever DTR turns ON. DTR dialing cannot be used if dial access security is enabled.
AT&T Exclusive ± Enables a subset of the proprietary AT&T command set, which is required for some applications that use AT&T equipment. Currently, the only application supported is AT&T DATAKIT.
The AT commands for AT are &M0, &M1, &M3 or &Q0, &Q1, &Q3.
The AT commands for DTR=Direct1 dialing are &M2 or &Q2.
November 1996 |