COMSPHERE 392xPlus Modems
Table
(3 of 4)
Line Dialer Configuration Options Ð Singleport Mode A
Long Space Disc: Enable
Nxt Enable Disable
Long Space Disconnect. Determines the modem's response to a continuous spacing condition sent from the remote modem before it goes
Enable ± Modem disconnects if it receives a continuous space from the DTE. For modulations lower than 4800 bps, the modem's transmitter will transmit 4 seconds of long space upon a disconnect.
Disable ± Modem does not disconnect if it receives a continuous space from the DTE. Modem will not transmit a long space disconnect.
The AT command for Disable is Y0.
The AT command for Enable is Y1.
No Carrier Disc: 2sec
Nxt 2sec Disable 5sec 10sec 20sec
No Carrier Disconnect. If the modem no longer receives carrier from the remote modem, it disconnects the call. This configuration option determines how long carrier is OFF before the modem disconnects. Loss of carrier is one method of disconnecting a call.
2, 5, 10, 20 sec ± Modem disconnects if carrier turns OFF for more than 2 seconds, 5 seconds, 10 seconds, or 20 seconds.
Disable ± Modem does not disconnect if carrier turns OFF.
NOTE: The range of allowable values may be restricted in some countries.
The AT command is
No Data Disc: Disable
Nxt Disable 10min 30min 60min
No Data Disconnect. Forces the modem to disconnect if no data is transmitted and received within a specified amount of time.
Disable ± Modem remains connected despite the lack of data flow.
10, 30, 60 min ± Modem disconnects if data is not received and transmitted within
NOTE: The factory default value is country dependent.
The AT command for Enable is \Tn, where n is from 1 minute to 255 minutes.
The AT command for Disable is \T0.
November 1996 |
