Paradyne 392xPLUS operation manual Only displays OK, CONNECT, RING, no Carrier, Error

COMSPHERE 392xPlus Modems

Table 5-2

(3 of 9)

392xPlus AT Commands

AT			Description			DCP LCD
						Command
Command
						Sequence
Xn	Extended Result Code, Dial Tone Detect, and Busy Tone Detect Configuration					Extended Result
	Options.					Code:
			Extended	Dial Tone	Busy Tone	Configure\Edit\
						DTE Dialer
			Result Code:	Detect:	Detect:	Dial Tone Detect:
	X0		Disable	Disable	Disable	Configure\Edit\
	X1		Enable	Disable	Disable	Line Dialer
	X2		Enable	Enable	Disable	Busy Tone
	X3		Enable	Disable	Enable
	X4		Enable	Enable	Enable	Detect:
	X5		Add/EC	Enable	Enable	Configure\Edit\
	X6		Add/V42.MNP	Enable	Enable	Line Dialer
	X7		Use DTE Rate	Enable	Enable
	Extended Result Code:
	Enable		Displays all result codes listed in Table 5-1 except for error
			control suffix.
	Disable		Only displays OK, CONNECT, RING, NO CARRIER,
			ERROR.
	Add/EC		Displays result codes with /EC suffix.
	Add/V42,MNP		Displays result codes with V.42 or MNP suffix.
	Use DTE Rate		Displays DTE data rate instead of line rate.
	Dial Tone Detect:
	Enable		Sets the modem for dial tone detect.
	Disable		Sets the modem for blind dialing.
	NOTE: It may not be possible to disable Dial Tone Detect in some countries.
	Busy Tone Detect:
	Enable		Modem monitors for busy tone.
	Disable		Modem ignores busy tone.
Yn	Long Space Disconnect.					Configure/Edit/
	Y0	Disable. Ignores long space.				Line Dialer
	Y1	Enable. Disconnects if long space is detected. Enables transmission
		of a long space.
Zn	Reset and Load Active.					Control\Reset
	Z0	Loads configuration options from Active (Saved) to Active
		(Operating).
	Z1	Loads configuration options from Customer 1 to Active (Operating).
	Z2	Loads configuration from Customer 2 to Active (Operating).
	Z3	Loads configuration options from Active (Saved) to Active
		(Operating) and performs a reset.

5-8 November 1996 3920-A2-GN31-30