DCP Operation
Leased:28.8
Control ExitRem
F1 F2 F3
If the remote modem accepts the password and the entry is successful, the
remote modem appears on the local modem's LCD. An 
appears in the upper
392xPlus modem. If the message Remote FP Busy appears, the remote modem's front panel is already in Remote mode.
ªStatusº
Status
Configure
PList
Control
Test
SubHS
Call_Setup
ExitRem
The
•The Talk/Data and Security branches do not appear.
•Change Directory is the only function available under the Call Setup branch.
•Local Analog Loop and Remote Digital Loop do not appear under the Test branch when using the secondary channel. When using the primary channel, the Test branch does not appear.
•Poll List Display is the only function available under the PList branch.
•Exit Remote replaces Remote on the local modem's LCD.
To return to local modem operation, select ExitRem. Any changes made to configuration options in the remote modem are saved.
The following conditions can cause Remote branch access to fail:
•The local modem is not able to communicate with the remote modem because of a poor dial network or
•If a connection is established but the remote modem's Access from Remote configuration option is disabled, then the status message Access Disabled appears on the LCD.
•If a connection is established but the wrong password is stored, the status message Password Invalid appears on the LCD. This configuration option must be enabled by the remote user. (Refer to the Remote Access Password configuration option in Chapter 4.)
•The remote mode command displays Other Test Active if an Analog Loopback test is currently running.
November 1996 |
